Canopus ADVC-HDM1 User's Guide download pdf (Page 11)

– 8 –

a LTC Output Terminal

This is the time code output (BNC) termi-

nal.

The HDV time code is output during HDV

decoding.

b LTC Input Terminal

This is the time code input (BNC) termi-

nal. A time code can be input for writing

to HDV during HDV encoding.

c ACTIVE THROUGH Terminal

This is the ACTIVE THROUGH terminal.

ACTIVE THROUGH is performed for the

input signal.

d SDI Input Terminal

This is the HD-SDI input terminal.

e SDI Output Terminal

This is the HD-SDI output terminal.

f Power Switch

This is the power switch. Use to turn the

ADVC-HDM1 ON or OFF.

g IEEE1394a 6-pin Terminal

This is an IEEE1394a 6-pin terminal. It

does not supply bus power.

h DIP Switches

Use to set the operation mode (refer to

the next page).

i RS-232C Terminal

The remote control terminal.

NOTE

The default setting for the encode bit rate via

RS-232C terminal remote control is 11 Mbps.

j RS-422 (CONTROLLER) Terminal

This is the RS-422 CONTROLLER termi-

nal. Connect as appropriate to the device

that you are using.

k RS-422 (DEVICE) Terminal

This is the RS-422 DEVICE terminal.

Connect as appropriate to the device that

you are using.

NOTE

Only use one of the following terminals at any

one time: RS-232C terminal, RS-422 (CON-

TROLLER) terminal and RS-422 (DEVICE).

l Power Terminal

Use to connect the supplied AC adapter.

Never connect to anything other than the

supplied AC adapter.

1-2 ADVC-HDM1 Rear Panel

a b

g

h i j k l

c d e f

ADVC_HDM1_EN.book Page 8 Tuesday, December 19, 2006 9:20 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments