Canopus ADVC-1000 User Manual download pdf (Page 18)

Basic InstructionsBasic Instructions

Basic Instructions

1010

Basic InstructionsBasic Instructions

Basic Instructions

4. DV input time code (Lower right on the screen)

32kHz/4ch > both

REC 00:00:03;22

00:00:03:22 .......... For PAL/NTSC NDF (Non Drop Frame)

* A colon is used between seconds and frames

as a delimiter.

00:00:03;22 .......... For NTSC DF (Drop Frame)

*A semicolon is used between seconds and

frames as a delimiter.

--:--:--:-- ................ No DV signal input

Main Screen 2

This screen shows information on the current settings.

1. Analog monitor audio output (Upper side on the screen)

Monitor out:1+3/2+4

TC source:DVITC NTSC

1/2 ......................... Outputs CH1/CH2.

3/4 ......................... Outputs CH3/CH4.

1+3/2+4 ............... Outputs MIX of CH1 and CH3, MIX of CH2

and CH4.

1+2+3+4 ............. Outputs MIX of CH1, CH2, CH3 and CH4.

2. Time code input (Lower middle on the screen)

Monitor out:1+3/2+4

TC source:DVITC NTSC

DVITC .................... DVITC signal in SDI video input signal is

acquired, and converted into time code

in output DV signal.

When deck control by remote connector is enabled

Acquires VITC through the remote con-

nector to use for time code. If VITC can-

not be acquired, DVITC in SDI video in-

put signal is used.

Info

Free-run time code is used

during built-in color bar output

or when a valid time code is not

in the DV signal.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

No comments

Canopus ADVC-1000 User Manual Page 18